in

Different Types of Concrete Mix

Different Types of Concrete Mix

Concrete is made up of cement, aggregate (particles of stone) and sharp sand. When you mix these ingredients with water, they bind into a solid, hard material. In different proportions, they produce concrete of different strengths for different uses.

It’s important to get the proportions right. If there’s too much aggregate, you’ll struggle to get a satisfactory finish. And too much sand will make the mix weak, so that the finished surface could be damaged by the elements.

Concrete begins to harden after about two hours and then becomes unworkable. But it doesn’t become really strong for several days, and continues to harden as long as there’s some moisture in it. Let’s take a look at below different types of concrete mix.

1. Nominal Mixes

In the past the specifications for concrete prescribed the proportions of cement, ?ne and coarse aggregates. These mixes of fixed cement-aggregate ratio which ensures adequate strength are termed nominal mixes. These offer simplicity and under normal circumstances, have a margin of strength above that specified. However, due to the variability of mix ingredients the nominal concrete for a given workability varies widely in strength.

Different Types of Concrete Mix

2. Standard mixes

The nominal mixes of fixed cement-aggregate ratio (by volume) vary widely in strength and may result in under- or over-rich mixes. For this reason, the minimum compressive strength has been included in many speci?cations. These mixes are termed standard mixes.

IS 456-2000 has designated the concrete mixes into a number of grades as M10, M15, M20, M25,M30, M35 and M40. In this designation the letter M refers to the mix and the number to the speci?ed 28 day cube strength of mix in N/mm2. The mixes of grades M10, M15, M20 and M25 correspond approximately to the mix proportions (1:3:6), (1:2:4), (1:1.5:3) and (1:1:2) respectively.

3. Designed Mixes

In these mixes the performance of the concrete is speci?ed by the designer but the mix proportions are determined by the producer of concrete, except that the minimum cement content can be laid down. This is most rational approach to the selection of mix proportions with specified materials in mind possessing more or less unique characteristics. The approach results in the production of concrete with the appropriate properties most economically. However, the designed mix does not serve as a guide since this does not guarantee the correct
mix proportions for the prescribed performance.

For the concrete with undemanding performance nominal or standard mixes (prescribed in the codes by quantities of dry ingredients per cubic meter and by slump) may be used only for very small jobs, when the 28-day strength of concrete does not exceed 30 N/mm2. No control testing is necessary reliance being placed on the masses of the ingredients.